Cart 0
KAM KWM1900 GB Wireless Audio Signal Sender


KAM KWM1900 GB Wireless Audio Signal Sender


This little device was designed primarily for wireless instrument transmission, guitars keyboards etc. Though it also works fantastically for sending any audio signal, a perfect alternative to having to run cables all over awkward venues, need to get a powered speaker running in a separate room? Just plug this little jobbie into a monitor out or main output of your mixer and connect the receiver into a powered speaker and there you go! Battery operated wireless audio sender!
Receiver Uses future proof frequencies UHF 863.00 - 865.00MHz Channel 70 frequency band Auto frequency scanning SMT technology Preset 16 channel PLL system Frequency stabilisation: < ±30ppm Dynamic range: > 100dB Total harmonic distortion: < 0.5% Frequency response: 40Hz-15KHz ±3dB Ideal working distance is up to 30 metres Power consumption: 100mA Signal to noise ratio: > 100dB Image & spurious rejection: > 80dB Border upon channel rejection: > 80dB Receiving sensitivity: 5dBuV (SINAD=30dB) De-emphasis: 50us RF output power: 10dB+/-1dB Spurious: -50dBm Modulation: 40K Pre-emphasis: 50u sec Maximum Input Level: +2dBV Input Impedance: 20K ohms THD: <0.8% (1KHz 100mV) Audio Frequency response: 50Hz-20KHz+/-3dB Operating Power Voltage: 1.5V (Typical 1.0v, Minimum 2v Max) Current consumption: 80mA Battery Life: 8 hours Antenna: permanently attached 1/4 wave length wire Controls: Power switch, 15dB Pad switch Indicators: Power on (LED flash) Low battery (LED ON when battery less than 1V ACT (LED flash)

Share this Product

More from this collection